According to the procedures after the production of a single tape, we must put the program and the production of a good tape one by one proofreading, with a good proof of the tape to the program after the controller can try to try the model, the simple grasp of the workpiece can be processed directly The On the size of the high precision, convex and concave mold with a small gap between the mold, we must use thin material test cut, engaged in cutting pieces can check its accuracy and with the gap. If you find that does not meet the requirements, should be timely analysis, identify the problem, modify the program until qualified before the formal processing of mold. This step is to avoid an important part of the workpiece scrap.